PowerBuilder 8.0.4 connecting to CVS

( CVSSCC )

Type: Public Status:Closed Created: 03 Mar 04 03:00 Updated: 03 Mar 04 03:00

--> Igor Pushkov (admin) at 03 Mar 04 03:00 writes

If I correctly understand you can not pull project on other PC, after
you add it one one PC. If so, please see:
http://www.sys-con.com/pbdj/article.cfm?id=271&count=10080&tot=4&page=3
Our plug-in is fully compatible to SCCI standard, those you can just
read general articles about PB and source control.
PB implementation of communication with Source Control is very
specific, and all our PB users says that sometime is hard to find
right sequence of operation, but this is possible, 100% sure.
Unfortunately, till this time we not have PB in our hands, to assist
you more effectively. However, at the end of this week we should
receive purchased copy of PB, and on the next week I will be able to
assist you.

--> Province of PEI Province of PEI (user) at 03 Mar 04 03:00 writes

Hello

I am using PowerBuilder 8.0.4 version and having a problem with connecting
throughout the driver to CVS server. For example one person add the project
to source control and other person on different PC doesn't see or it
doesn't show that was add to source control therefore we can not proceed
any further. One point it add some but not all of them. If any one could
help me or give a hint that would be great.

Rate this ticket:

Not useful at all

Partially useful

Useful

Very useful

Ticket

PowerBuilder 8.0.4 connecting to CVS